What a no-heat call involves
Start with the simple checks. Is the thermostat set to heat and calling for it? Is the boiler switch on? Is there power and fuel? Is the pressure gauge in the normal range, which for many residential systems is roughly 12 to 15 psi cold? If those are fine, the problem is in the boiler or the distribution.
A plumber checks for a tripped limit, a failed circulator pump, stuck zone valves, trapped air in the system, a low water level or an ignition problem. Safety comes first. If there is any sign of gas or carbon monoxide, leave the building and call emergency services.
Common boiler problems
Cold radiators
Air in the system, a failed circulator or a closed valve can stop hot water reaching them. Bleeding a radiator may help, but a pump failure needs a plumber.
Low or high pressure
A leak, a failed expansion tank or a stuck fill valve changes system pressure.
Short cycling
The boiler turns on and off quickly. Causes include an oversized unit, bad sensor or blocked flue. It wastes fuel and wears parts.
Leaks and drips
A leak at a valve, relief valve or the boiler body needs attention. A leak from the body often means replacement.
Repair or replace
A boiler can last a long time with maintenance, but repeated repairs on an old unit add up. We tell you if the cost of the repair approaches the value of a new boiler. Replacement is a planned project with sizing, venting and piping changes, and we can discuss it after the emergency.
Hot water from an indirect tank off the boiler is a different system from a standalone tank heater. For tank problems, see water heater repair. For burst heating pipes, see burst pipe repair.
Cold radiator checklist
| Check | What it means | Next step |
|---|---|---|
| Thermostat | Set to heat, batteries fresh | Raise the setting. |
| Boiler pressure | Low or very high reading | Call a plumber. |
| Radiator cold at top | Air trapped | Bleed the radiator. |
| Radiator cold at bottom | Sludge or a closed valve | Plumber inspection. |
No heat tonight?
Call now. We dispatch around the clock and will tell you what to check first.
East Hartford note: homes, fuel and permits
Many East Hartford homes heat with hydronic baseboard or radiators fed by gas or oil boilers. For a gas odor, call 911 and your gas utility. Fuel type affects who must work on the burner, so tell us what your boiler burns.
Replacing a boiler normally involves a permit. Ask the East Hartford Department of Inspections and Permits at (860) 291-7340. Oil and gas burner work may require a separately licensed trade, and we tell you when that applies.
Boiler piping, relief valves and backflow protection on the fill line are regulated by the International Plumbing Code (IPC) and the mechanical rules of the Connecticut code. The 2022 code adopts the 2021 IPC.
What affects the cost of boiler repair
The part and the time of the call set the price.
Insurance usually does not cover a worn-out boiler. A burst pipe from a freeze after heat failure can be covered.
Common questions
Yes. A no-heat call in winter is urgent, and the line is staffed around the clock.
Many home systems run around 12 to 15 psi when cold. Check your manufacturer manual, and call if it reads well outside that.
Trapped air, water hammer or low water level are common causes. A plumber can find which.
No. Leave the home and call 911 and your gas utility first. We can work after the utility clears it.
Often it follows a heat failure. See burst pipe repair.
